Stucco Installation Kelowna, BC
Stucco installation means applying a cement or acrylic cladding system, often called stucco siding, over a building’s exterior walls to protect them from weather and give them a finished look. We install hard coat and EIFS stucco on new homes, additions and commercial buildings in Kelowna and across the Central Okanagan.
We work with builders, general contractors and homeowners from the moment the sheathing goes on to the final finish coat.
New Construction Stucco for Kelowna Builders
Kelowna is one of the busiest construction markets in B.C. According to CPABC, housing starts in Kelowna rose 27.6% in 2024 to 3,790 units, and nearly 90% of them were attached homes such as townhouses and apartments. More projects mean tighter schedules, so a stucco crew that shows up when planned keeps every trade after it on track.
We coordinate with your site superintendent on window installation, flashing and inspections before we start. On multi-unit and commercial projects, we plan scaffolding and phasing so stucco work moves with the build instead of holding it up.
Our Hard Coat Stucco Installation Process
Hard coat stucco is a traditional three-coat cement system. Each layer has a specific job, and skipping steps or rushing cure times is the most common cause of early cracking.
- Wall inspection. We check sheathing, window and door flashing, and transitions before any material goes on.
- Weather-resistive barrier. A sheathing membrane is installed to shed any water that gets behind the stucco.
- Lath and accessories. Metal lath, weep screeds, corner beads and control joints are fastened to the framing.
- Scratch coat. The first cement coat is pressed into the lath and scored to grip the next layer.
- Brown coat. A second coat builds thickness and creates a flat, even surface.
- Curing. Each coat is allowed to cure properly, with misting in hot, dry Okanagan weather.
- Finish coat. A coloured cement or acrylic finish is applied in the texture you choose.
Hard Coat vs EIFS Stucco Installation
Choosing a stucco system depends on your budget, energy targets and how much impact resistance the walls need. Here is how the two systems we install most compare.
Feature Hard coat stucco EIFS Base Cement over metal lath Rigid foam insulation board Thickness About 7/8 inch, three coats Thin finish over insulation Insulation value Low on its own High, continuous exterior insulation Impact resistance Very high Moderate Starting cost About $7 to $8 per sq. ft. About $11 to $12 per sq. ft. Best for Durability, lower budgets Energy efficiency, modern design Energy rules are a growing factor. Since May 1, 2023, the BC Energy Step Code has required new Part 9 buildings, including most houses and small commercial buildings, to meet Step 3, which means 20% better energy efficiency than a building built to the 2018 BC Building Code. Continuous exterior insulation can help builders meet those targets, which is why many new projects now use EIFS cladding systems.
Stucco Finishes and Colours for New Homes
The finish coat sets the final look of your home. Cement finishes give a classic, mineral appearance, while acrylic finishes offer brighter, more consistent colour and better flexibility. Textures range from smooth and sand-float to heavier dash and lace patterns. Browse our stucco colours and textures to compare options before you choose.
Stucco for Home Additions and Re-Stucco Jobs
Additions are tricky because the new wall needs to match a surface that has weathered for years. We match the texture, colour and control joint layout so the addition looks like part of the original house, not an afterthought.
For older homes, a full re-stucco replaces worn cladding with a new system and a fresh finish. It is a chance to correct past flashing problems and update the colour at the same time. If your existing walls only need patching, our team can repair existing stucco instead.
Why Builders Choose Our Stucco Installation Team
Stucco Kelowna brings decades of hands-on experience on residential and commercial projects across the Central Okanagan. We have seen how stucco performs through Okanagan winters and summers, and we build every wall with that in mind.
Builders and homeowners work with us because we keep clean, organized sites, communicate clearly and finish on schedule. Qualifying installations are backed by our 5-year workmanship warranty, and you can review typical pricing in our stucco pricing guide.
Stucco Installation FAQ
Most new single-family homes take two to four weeks from lath to finish coat. Traditional three-coat stucco needs curing time between coats, often about a week before the finish coat. Weather, home size and design details change the timeline.
Yes, with precautions. Fresh stucco must not freeze before it gains strength, and manufacturers typically call for at least 5°C during application and curing. In winter, we enclose the walls with tarps and run heaters until each coat has set.
Yes. Much of our new construction work comes from builders and general contractors. We provide itemized quotes, coordinate with other trades and schedule our crew around your build so stucco never becomes the bottleneck.
Yes. We match the existing texture, colour and joint layout using sample patches before we finish the full wall. Older stucco may have faded, so we sometimes recommend a fresh finish coat across both surfaces for a seamless look.
Get a Stucco Installation Quote in Kelowna
Planning a new build, addition or re-stucco? Call (236) 301-5150, or send your plans through the form for an itemized quote. You can also see our full list of services for related exterior work.